Gerüst

Creating the framework from the anatomic shape (Shrinking/Cutback)

If your construction contains anatomic copings, reduced pontics/waxups, or overpress parts, the wizard will present you the „Shrinking“ dialog. This screen allows you to reduce the anatomic shapes in order to create the framework. Note that we are talking about cutback for applying ceramic here.
Tip This has absolutely nothing to do with the zirconia shrinking that occurs during the sintering process.

You may change the minimum thickness of the framework using [1], within the margins defined for the material you selected.
Slider [2] controls the amount of cutback – that is, the thickness of the ceramic layer you plan to apply on the framework.
Note that the minimal thickness will always be enforced, which means that in areas where the material thickness does not allow it, the cutback will be less than what is specified by [2].

07-shrinking01.jpg

Partial shrinking

Dcad 08.jpg

You may exclude certain parts from the shrinking, which will then be kept in full anatomic shape. This is useful e.g. for creating lingual bands, or for designing a metal chewing surface if you don't have enough space for ceramic on the occlusal side. Check [3] – observe how the teeth then turn yellow; they are now responsive to mouse actions. Drag and drop the mouse on the teeth to mark areas that will be excluded from the shrinking.

Hotkey Hold <SHIFT> to erase

Slider [4] controls the thickness of the brush used for marking.

In some cases, it may be beneficial to have less reduction on the lingual side. You can achieve this result by setting slider [5] to a value below 100%. E.g. if you have set a depth of 1mm [2], and set [5] to 60%, then the shrinking will be just 0.6mm on the lingual side. By default, this lowered value is only applied to anterior teeth; to apply it to all teeth, uncheck [6].

Click „Apply“ [7] to perform the shrinking without switching to the next wizard screen, or click „Next“ to shrink and move on.